2) If you own a Laurastar ironing system (such as Laurastar S4a, Laurastar S5a, Laurastar S6a, Laurastar S7a, Laurastar Pulse, Laurastar S, Laurastar S PLUS, Laurastar S Xtra, Laurastar S PURE, Laurastar S PURE PLUS, Laurastar S PURE XTRA ):Remove the water tank without switching off the ironing system, fill it with cold tap water up to the MAX level then put the water tank back in the boiler.
3) If you own a Laurastar ironing system Laurastar Go or Laurastar Go +:1. Check that the plug is disconnected.2. Set the board to its highest position.3. Fill the refill bottle supplied with water. Equipped with an anti-overflow mechanism, it will stop filling up when the water tank is full (the capacity of the bottle is greater than that of the boiler).4. Unscrew the refill cap and place the mouth of the bottle in the hole.5 Briefly squeeze the bottle to start the water flowing.6. When full, carefully screw the refill cap back on.
4) If you own a Laurastar steam generator Laurastar Lift, Lift Xtra or Laurastar Lift +: 1. Lift the cover of the water tank2. Keep the cover of the water tank open3. Remove the water tank by pulling on its cover4. Fill the tank with tap water
Then, to put back the water tank:1. Lift the cover of the water tank.2. Keep the cover open.3. Push the water tank back into its place, with the cover open, then close the cover.
As a Laurastar owner, you can join our Club and enjoy exclusive advantages, so sign up!
You can read them here